Logout; Ping; Reload - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

15.2.11 logout

This command closes the current telnet connection or resets the current serial connection.
Note: Save configuration changes before logging out.
Format
Mode

15.2.12 ping

This command checks if another computer is on the network and listens for connections.
To use this command, configure the switch for network (in-band) connection. The source
and target devices must have the ping utility enabled and running on top of TCP/IP. You
can ping the switch from any IP workstation the switch is connected to through the default
VLAN (VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends three pings to the target station.
Format
Modes

15.2.13 reload

This command resets the switch without powering it off. Reset means that all network
connections are terminated and the boot code executes. The switch uses the stored
configuration to initialize the switch. You are prompted to confirm that the reset should
proceed. The LEDs on the switch indicate a successful reset.
Format
Mode
System Maintenance Commands
logout
Privileged EXEC
ping <ipaddr>
Privileged EXEC, User EXEC
reload
Privileged EXEC
v1.0, February 2007
15-21