Logout; Ping; Reload - NETGEAR ProSafe GSM7224 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Mode

logout

This command closes the current telnet connection or resets the current serial connection.
Note: Save configuration changes before logging out.
Format
Mode

ping

This command checks if another computer is on the network and listens for connections. To use
this command, configure the switch for network (in-band) connection (as described in the 7200
Series L2 Switch
2402/4802 Hardware User Guide
utility enabled and running on top of TCP/IP. The switch can be pinged from any IP workstation
with which the switch is connected through the default VLAN (VLAN 1), as long as there is a
physical path between the switch and the workstation. The terminal interface sends, three pings to
the target station.
Format
Mode

reload

This command resets the switch without powering it off. Reset means that all network connections
are terminated and the boot code executes. The switch uses the stored configuration to initialize
the switch. You are prompted to confirm that the reset should proceed. A successful reset is
indicated by the LEDs on the switch.
Format
Mode
Switching Commands
copy <url> nvram:sshkey-dsa
Privileged EXEC
logout
Privileged EXEC
). The source and target devices must have the ping
ping <ipaddr>
Privileged EXEC and User EXEC
reload
Privileged EXEC
202-10009-01_060204
8-113