Show Ip Mcast Mroute; Show Ip Mcast Mroute Group - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

show ip mcast mroute

This command displays a summary or all the details of the multicast table.
Format
show ip mcast mroute {detail | summary}
Modes • Privileged EXEC
• User EXEC
If you use the detail parameter, the command displays the following fields:
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Expiry Time The time of expiry of this entry in seconds.
Up Time The time elapsed since the entry was created in seconds.
RPF Neighbor The IP address of the RPF neighbor.
Flags The flags associated with this entry.
If you use the summary parameter, the command displays the following fields:
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Protocol The multicast routing protocol by which the entry was created.
Incoming The interface on which the packet for the source/group
Interface
arrives.
Outgoing The list of outgoing interfaces on which the packet
Interface List
is forwarded.

show ip mcast mroute group

This command displays the multicast configuration settings such as flags, timer settings, incoming
and outgoing interfaces, RPF neighboring routers, and expiration times of all the entries in the
multicast mroute table containing the given <groupipaddr>.
Format
show ip mcast mroute group <groupipaddr> {detail |summary}
Modes • Privileged EXEC
• User EXEC
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-5