No Ip Dhcp Excluded-Address; Ip Dhcp Ping Packets; No Ip Dhcp Ping Packets; Ip Dhcp Pool - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Format
Mode

no ip dhcp excluded-address

This command removes the excluded IP addresses for a DHCP client. Low-address and high-
address are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP
address 0.0.0.0 is invalid.
Format
Mode

ip dhcp ping packets

This command is used to specify the number, in a range from 2-10, of packets a DHCP server
sends to a pool address as part of a ping operation. By default the number of packets sent to a pool
address is 2(the smallest allowed number when sending packets). Setting the number of packets to
0 disables this command.
Note: The no form of this command sets the number of packets sent to a pool address to 0 and
therefore prevents the server from pinging pool addresses.
Default
Format
Mode

no ip dhcp ping packets

This command prevents the server from pinging pool addresses and sets the number of packets to
0.
Default
Format
Mode

ip dhcp pool

This command configures a DHCP address pool name on a DHCP server and enters DHCP pool
configuration mode.
Switching Commands
ip dhcp excluded-address <lowaddress> [highaddress]
Global Config
no ip dhcp excluded-address <lowaddress> [highad-
dress]
Global Config
2
ip dhcp ping packets <0,2-10>
Global Config
0
no ip dhcp ping packets
Global Config
202-10102-01, May 2005
8-85