Show Classofservice Ip-Dscp-Mapping; Show Classofservice Trust - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Format
Mode
The following information is repeated for each user priority.
IP Precedence
Traffic Class
Note: This command is only supported on the GSM7248.

14.1.10 show classofservice ip-dscp-mapping

This command displays the current IP DSCP mapping to internal traffic classes for the
global configuration settings.
Format
Mode
The following information is repeated for each user priority.
IP DSCP
Traffic Class

14.1.11 show classofservice trust

This command displays the current trust mode setting for a specific interface. The unit/
slot/port parameter is optional and is only valid on platforms that support independent per-
port class of service mappings. If specified, the port trust mode of the interface is
displayed. If omitted, the most recent global configuration settings are displayed.
Format
Mode
Non-IP Traffic
Class
14-6
show classofservice ip-precedence-mapping [unit/
slot/port]
Privileged EXEC
The IP Precedence value.
The traffic class internal queue identifier to which the IP Pre-
cedence value is mapped.
show classofservice ip-dscp-mapping
Privileged EXEC
The IP DSCP value.
The traffic class internal queue identifier to which the IP
DSCP value is mapped.
show classofservice trust [unit/slot/port]
Privileged EXEC
The traffic class used for non-IP traffic. This is only dis-
played when the COS trust mode is set to trust ip-precedence.
v1.0, February 2007
Quality of Service (QoS) Commands