Table of Contents
Advertisement
Chapter F - PATIENT SUPPORT ARM
3 REPLACING THE GUI SOFTWARE
The software update for a colour GUI is explained in section 3.1 "GUI software update, only
for colour GUI" on page F-10 and the software update for black/white GUI is explained in sec-
tion 3.2 "Replacing GUI software chip, only for black/white GUI" on page F-11.
3.1 GUI software update, only for colour GUI
NOTE
The colour GUI software has to be updated every time when the X-ray unit software is
updated.
The GUI software can be updated by choosing Software update (i590) from the Service Set-
tings (i500) menu.
Figure 13
When touching the Update button the GUI software update procedure starts and a text
"Updating GUI software" occurs on the screen. When the procedure is completed the GUI
restarts and returns automatically to Software Update (i590) menu. The exit of the mode is by
touching the Done field.
NOTE
If there are several GUIs connected to the ProMax X-ray unit then the software update
has to be done for every GUI separately. Detach other GUIs while updating the software
to one of them.
F-10 ProMax X-ray unit with Dimax3
REPLACING THE GUI SOFTWARE
Technical Manual
Advertisement
Table of Contents
