Gui Software - Planmeca Proline XC Technical Manual

REPLACING THE SOFTWARE

5.3 GUI software

Technical Manual
Switch off the X-ray unit. Connect the Software loading cable (Planmeca part number
10003926) to the PS/2 connector at the underside of the user interface.
Connect the other end of the Software loading cable to the computer serial port COM1 or
COM2.
Figure 9
Touch the GUI with your finger and switch on the X-ray unit. You will hear a signal tone and a
display shown below appears.
Figure 10
Chapter H - PARTS REPLACEMENT & REPAIR
Planmeca Proline XC X-ray unit H-11