Planmeca ProMax X-ray Instruction Manual page 43

SPECIAL FUNCTIONS
4.6.1 Ethernet
4.6.2 TCP/IP
NOTE
Technical Manual
Select Ethernet mode (i481 ) selection on the Network Settings display. The display shown
below appears.The Network Mode can be chosen as Auto-negotiation, 10/100 Mb Full-
duplex or 10/100 Mb Half-duplex. The MAC-Address is equipment related and it cannot be
changed.
Figure 28
Select TCP/IP mode (i482) selection on the Network settings display. The display shown
below appears. All the default defined settings can be changed by touching the address field.
Figure 29
IP Address - The Ethernet interface IP Address (default value is 192.168.0.130)
Netmask - Subnet mask (default value is 255.255.252.0)
Gateway - Gateway address (default value is 192.168.1.2)
In case the ProMax is connected to a 10/100 Base Network, the Gateway and the Pro-
Max IP address have to be static and specified by the local administrator to be used
only for this configuration.
Chapter B - INFORMATION DISPLAYS
ProMax X-ray unit with Dimax3 B-19