Installing The Dimaxis/Romexis Imaging Software; Installing The Calibration Files - Planmeca ProOne Installation Manual

8.4

Installing the Dimaxis/Romexis imaging software

8.5

Installing the calibration files

NOTE Use only the original calibration file CD-ROM supplied with the Planmeca ProOne X-
Installation Manual
Printed copies of this document are considered uncontrolled.
7535.13.Rev001 08.07.2018
Install the software according to the instructions given in the software installation manual.
Install the calibration files according to the instructions given in the software installation
manual, Appendix DIDAPI CONFIGURATION.
ray unit - you cannot perform the calibration without the original files. Leave the
original CD-ROM at the office where the X-ray unit is installed.
INSTALLING THE DIGITAL SYSTEM
Planmeca ProOne 25