Table of Contents
Advertisement
•
Make sure that there is no voltage on the AC input cables during the complete
installation procedure.
•
Keep unqualified personnel at a safe distance during installation.
•
Only use electrical wires of sufficient gauge and insulation to handle the rated
current and voltage demand.
•
Make sure that the load capacity of the grid is in accordance with the EVSE.
•
Earth the EVSE correctly. Refer to section 2.10.
•
Make sure that the wiring inside the EVSE is protected from damage and cannot
get trapped when you open or close the cabinet.
•
Make sure that water cannot enter the cabinet.
•
Protect the EVSE with safety devices and measures that the local rules specify.
•
If it is necessary to remove safety devices for maintenance or repairs,
immediately install the safety devices after the work is completed.
•
Put on the correct personal protective equipment. Refer to section 2.5.
2.8
Safety instructions for use
Do not use the EVSE and immediately get in contact with the manufacturer if the
safety or the safe use of the EVSE is at risk. This includes, but is not limited to, these
conditions:
•
An enclosure has damage.
•
An EV charge cable or connector has damage.
•
Lightning struck the EVSE.
•
There was an accident or a fire at or near the EVSE.
•
Water entered the EVSE.
2.9
Safety instructions during cleaning or maintenance
Preliminary requirements
•
Keep unauthorized personnel at a safe distance during cleaning or maintenance.
•
If for cleaning or maintenance it is necessary to remove safety devices,
immediately install the safety devices after the work.
•
Put on the correct personal protective equipment. Refer to section 2.5.
2.10
Safety instructions for earthing
Preliminary requirements
HVC 200/300/360-EN | 002
•
•
Safety
17
Advertisement
Table of Contents
