Table of Contents
Advertisement
Arbitrarily Configuring the Name of Filter Cube
2.3.2
When the filter cube attached to the microscope is not on the list, you can configure any name. The name arbitrarily
configured is registered to the memory (memory address 1 through 10). If you are using two epi-fluorescence cube turrets
(motorized or intelligent) by layering them on top of each other, you use a single list of registered names for both layers.
[Procedure]
[MIC SETUP] → [COMPONENTS]
(1)
Select the [FL TURRET] tab.
When you want to configure settings for the second
epi-fluorescence cube turret, select the [FL 2nd] tab.
(2)
Press the turret address button to be configured.
(3)
Press the [CUSTOM] button on the filter cube
configuration screen.
The condenser modules registered to the memory are
displayed.
To quit setting, press the [X] button.
When the filter cube name is already
registered to the memory
If the name of the filter cube to be used is already
registered to the memory, you can complete the
configuration by selecting the filter cube from the
list and pressing the [OK] button.
(4)
Select the memory address (1 - 10) to which you want
to register (or modify) the data.
Chapter 6
Settings
1-87
Advertisement
Table of Contents
Troubleshooting
