Table of Contents
Advertisement
(9)
Press the [INPUT] button, enter the working distance
of the attached objective, and then press the [ENTER]
button.
Pressing the
button removes a character at the end of
the data you entered.
(10) Press the [NEXT] button.
(11) Press the [INPUT] button, enter the name of the
attached objective (up to twenty characters), and then
press the [ENTER] button.
Pressing the
button removes a character at the end of
the data you entered.
Pressing the
button toggles between upper and lower
cases for alphabet letters.
(12) Press the [OK] button.
The objective is set to the nosepiece address.
After configuring, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the microscope's
memory (DS-L4's memory if LV150A or LV-NCNT2, or memory of nosepiece controller if LV-NCNT-N). If the microscope is
turned off without saving settings, previous values are restored. For more information on saving, see "1 Bulk Saving of
Settings ([MAIN] Screen)" in this chapter.
Chapter 3
Settings
2-18
Advertisement
Table of Contents
Troubleshooting
