Table of Contents
Advertisement
(3)
Select the name of the series of the objective attached
to the microscope and press the [NEXT] button.
When [▲] and [▼] buttons are shown under the list, you
can press [▲] or [▼] button to go to other pages.
To quit setting, press the [X] button.
(4)
Select the magnification of the objective attached to
the microscope and press the [NEXT] button.
To return to the previous screen, press the [BACK] button.
(5)
Select the product code of the objective attached to
the microscope and press the [OK] button.
The selected objective is set to the nosepiece address.
If multiple objectives with the same
specification are shown
If multiple objectives with the same specification
(such as magnification/NA/support of
immersion/microscopy method) are shown, select
the one whose first digit of the product code is the
biggest.
(6)
Repeat steps (2) to (5) for all nosepiece addresses to
be configured.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-79
Advertisement
Table of Contents
Troubleshooting
