Table of Contents
Advertisement
Retracting the Elevating Section
1.18.2
[Procedure]
(1)
Press the [XYZ] button.
(This operation is not required if the [ESCAPE] button
is already displayed on the [MIC EASY] screen. Go to
the next step.)
(2)
Press the [ESCAPE] button.
The elevating section is moved to the position specified for
the [ESCAPE DISTANCE] and enters the escape state.
For details on the escape distance, refer to Chapter 6, "5.2
Setting the Retracting Amount of the Elevating Section".
The following are disabled in retracted state:
-
Focus knob of the microscope, ergo controller, and
joystick
-
[Specimen Removal Position] button
Also, the display of Z coordinate on the [MICROSCOPE
CONTROL] screen flashes.
Press the button again to return to the original position.
The retracted state is reset and the focus knob and
[Specimen Removal Position] button are enabled.
Chapter 5
Individual Operations
[MICROSCOPE CONTROL] Screen
[MIC EASY] Screen
1-65
Advertisement
Table of Contents
Troubleshooting
