Configuring The Eyepiece Information (Only For Smz18 And Smz25) - Nikon DS-L4 Instructions Manual

Configuring the Eyepiece Information (Only for SMZ18 and SMZ25)

2.3
This section describes the setup procedure for the eyepiece attached to the binocular section.
[Procedure]
[MIC SETUP] → [COMPONENTS]
(1) Select the [EYEPIECE] tab.
(2) Press the eyepiece button to be configured.
If the eyepiece is displayed as [-----], information for the
eyepiece is not configured. By default, the button is
displayed as [-----].
(3) Select the eyepiece attached to the microscope and
press the [OK] button.
The eyepiece information is set.
To quit setting, press the [X] button.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 3
Settings
2-22