Table of Contents
Advertisement
Arbitrarily Configuring the Name of Condenser Module
2.2.2
When the condenser module attached to the microscope is not on the list, you can configure any name. The name
arbitrarily configured is registered to the memory (memory address 1 through 10).
[Procedure]
[MIC SETUP] → [COMPONENTS]
(1)
Select the [CONDENSER] tab.
(2)
Press the turret address button to be configured.
(3)
Press the [CUSTOM] button on the condenser module
configuration screen.
The condenser modules registered to the memory are
displayed.
To quit setting, press the [X] button.
When the module name is already
registered to the memory
If the name of the module to be used is already
registered to the memory, you can complete the
configuration by selecting the condenser module
from the list and pressing the [OK] button.
(4)
Select the memory address (1 - 10) to which you want
to register (or modify) the data.
Chapter 6
Settings
1-84
Advertisement
Table of Contents
Troubleshooting
