Devices Whose Status Is Viewable On Ds-L4 - Nikon DS-L4 Instructions Manual

Chapter
1

Devices Whose Status Is Viewable on DS-L4

WARNING
Before using this product, thoroughly read the "Safety Precautions" at the beginning of the "Camera Operation"
separately provided and be sure to follow the warnings and precautions indicated therein.
In addition, thoroughly read the instruction manuals for the products used with this system (such as microscope main
body or motorized accessory devices) and be sure to follow the warnings and precautions indicated therein.
Procedure for Connecting Each Device
For details on the procedure for connecting the microscope main body, DS-L4, and individual parts, refer to the
instruction manual of your microscope and also the "Camera Operation" instruction manual of DS-L4.
By connecting the DS-L4 microscope camera control unit to the microscope, the status of the microscope and accessories
can be displayed on DS-L4.
This chapter describes the microscopes and accessories whose statuses can be viewed on the DS-L4 microscope
camera control unit and the required settings.
Devices Whose Status Is Viewable on the DS-L4
1
Connected to ECLIPSE L200N/L200ND/L300N/L300ND
When the DS-L4 is connected to ECLIPSE L200N/L200ND/L300N/L300ND, the status of the following devices is viewable
on DS-L4.
Configurations required before using accessories vary depending on the type of accessories you use. Refer to the
following table to perform the required configuration.
Device
ECLIPSE L200N/L200ND/L300N/L300ND
microscopes
C-HGFIE HG Precentered Fiber Illuminator
(motorized)
-
Chapter 1
Devices Whose Status Is Viewable on DS-L4
Information Viewable on DS-L4
Address of nosepiece in optical
path, objective information
Status of EPI aperture diaphragm
Epi-illumination ON/OFF, lamp
voltage
Dia-illumination ON/OFF, lamp
voltage (Only for L200ND and
L300ND. However, epi-illumination
lamp and dia-illumination lamp
cannot be used at the same time.)
Open/close state of the built-in
shutter, built-in ND dimming value
Current microscopy method
Information on attached
objectives
(See Chapter 3, "2.1 Configuring
the Objective Information")
None
None
None
2-1
Required Configuration
None
None