(5)
Press the [OK] button.
Filter cube is set to the turret address.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
For SMZ18/SMZ25
See "2.3.2 Arbitrarily Configuring the Name of Filter Cube" in Chapter 6 of Part 1 for configuration procedures.
Chapter 3
Settings
2-21