Table of Contents
Advertisement
(5)
Press the [MODIFY] button and then [OK] button.
To cancel adding or saving, press the [CANCEL] button.
Removing the filter cube name registered
to the memory
To remove the filter cube name registered to a
memory address, press the [DELETE] button. If
the filter cube name to be removed has been
registered to an turret address, settings in the
turret address will also be removed.
(6)
Press the [INPUT] button, enter the name of the
attached filter cube (up to five characters), and then
press the [ENTER] button.
Pressing the
button removes a character at the end of
the data you entered.
Pressing the
button toggles between upper and lower
cases for alphabet letters.
(7)
Press the [OK] button.
(8)
Select the filter cube registered to the memory
address and press the [OK] button.
The selected filter cube is set to the turret address.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-88
Advertisement
Table of Contents
Troubleshooting
