Table of Contents
Advertisement
(5)
Select the motorized devices for which the state is to
be restored.
The device is selected or unselected each time the button
is pressed.
To return to the previous screen, press the [BACK] button.
(6)
Press the [OK] button.
You will be taken back to the [MODE] screen.
When the target device is changed
After changing the target devices subjected to
loading, adjust the states of all target devices and
then press the [SAVE] button to save the current
position of the devices. (For details on saving the
current position, refer to "2.2 Saving/Updating a
Mode (State of Motorized Devices)".)
When a motorized device selected as the target of
loading is unselected and then selected again, or
when a mode is once deleted and then re-registered
to the same number, neglecting the above procedure
will result in the previously saved position being
restored.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in Chapter 6.
Chapter 5
Individual Operations
1-69
Advertisement
Table of Contents
Troubleshooting
