Table of Contents
Advertisement
Enabling or disabling the parfocal correction
In this section, you enable or disable the parfocal correction function. If you want to use the parfocal correction function,
you have to set the focal point in advance. If the focal point is not set after attaching the objective, see the previous section
"Configuring the focal point".
Setting Item
Setting Value
[AUTO LINK
ON
FOCUS]
OFF (default)
[MIC SETUP] → [MOVEMENT]
(1)
Press the [SET] button under [OBJECTIVE
INTERLOCK].
(2)
Set [AUTO LINK FOCUS] as appropriate.
To quit setting, press the [X] button.
(3)
Press the [OK] button.
[MOVEMENT] screen is displayed.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
Operation to Be Interlocked
Enables parfocal correction.
Disables parfocal correction.
1-123
Advertisement
Table of Contents
Troubleshooting
