Information Screen For Smz18/Smz25 Stereo Microscope - Nikon DS-L4 Instructions Manual

7

Information Screen for SMZ18/SMZ25 Stereo Microscope

The display appearance depends on the configuration or setting of the microscope.
On the window only devices that are connected to the microscope (P2-CTLA/P2-CTLB control box) and
detected by the DS-L4 are displayed.
Therefore, the display appearance will depend on the configuration of the microscope. See Chapter 1 "Devices
for Which Their Status Can be Detected by DS-L4" for the devices that can be detected by the DS-L4 from your
microscope zooming body and accessories.
The Info window displays the status of the microscope.
MIC EASY Screen
Shows/hides magnification on
DS-L4 monitor
Zoom magnification
Nosepiece:
Address icon, objective name
Epi-fluorescence cube turret:
Address icon, epi-fluorescence
filter cube name
Epi-illumination:
Open/close state of the built-in
shutter, built-in ND dimming value
Diascopic illumination LED:
ON/OFF, brightness level
Current Z position of the vertical
movement section
INFO Window
Zoom magnification
Nosepiece:
Address number, objective name
Epi-fluorescence cube turret:
Address number,
epi-fluorescence filter cube name
Diascopic illumination LED:
ON/OFF
Chapter 2
Viewing the Status of Microscope on DS-L4
Switches the displayed content.
Closes the INFO window.
Shows/hides magnification on
DS-L4 monitor.
(Displayed only when display is
turned ON on the MIC EASY
screen)
Epi-illumination:
Open/close state of the built-in
shutter, built-in ND dimming
value
2-11
Closes the information screen.
Magnification on DS-L4 monitor
(When the relay lens
magnification is not entered,
"-------" is shown on the display.
Enter the relay lens
magnification at the camera
setting. When the relay lens is
not used, enter "1.00". For
details, refer to the description of
calibration value registration in
the "Camera Operation"
instruction manual.)
Z position status of the vertical
movement section:
ESCAPE
UNDER LIMIT
Blank (Other)