Arbitrarily Configuring the Data of Objective
2.1.2
When the objective attached to the microscope is not on the list, you can arbitrarily configure the objective's data. (Only for
MA200, L200N/L200ND, L300N/L300ND, LV150A, LV-NCNT2, LV-NCNT-N, and LV100DA-U)
[Procedure]
[MIC SETUP] → [COMPONENTS]
(1)
Select the [NOSEPIECE] tab.
The screens in the following procedure are for
LV100DA-U. They vary depending on the model.
(2)
Press the nosepiece address button to be configured.
(3)
Press the [CUSTOM] button on the objective
configuration screen.
To quit setting, press the [X] button.
(4)
Select the name of the series of the objective attached
to the microscope and press the [NEXT] button.
When [▲] and [▼] buttons are shown at the lower edge of
the list, you can press [▲] or [▼] button to go to other
pages.
Chapter 3
Settings
2-16