Setting The Driving Speed Of The Epi-Fluorescence Cube Turret - Nikon DS-L4 Instructions Manual

Setting the Driving Speed of the Epi-Fluorescence Cube Turret

6.5
When you use a filter cube which includes the thick dichroic mirror, you must lower the movement speed of the
epi-fluorescence cube turret.
If you are using two layered motorized epi-fluorescence cube turrets, configure 1st and 2nd layers separately.
Prerequisite for configuration
In order to perform this configuration, the motorized epi-fluorescence cube turret must be attached.
Setting Item
[EPI-FLUORESCENCE CUBE
TURRET]
[2nd EPI-FLUORESCENCE CUBE
TURRET]
(When using two layered motorized
epi-fluorescence cub turrets)
[Procedure]
[MIC SETUP] → [MAINTENANCE]
Select a movement speed from the options shown in the [FL
TURRET DRIVE SPEED] section.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
Setting Value
[HIGH] (default) When using only standard filter cube
[LOW] When using any filter cube which includes thick
dichroic mirror
[HIGH] (default) When using only standard filter cube
[LOW] When using any filter cube which includes thick
dichroic mirror
1-142
Description