Table of Contents
Advertisement
Arbitrarily Configuring the Name of Filter Cube (Only for LV100DA-U, SMZ18, and
2.2.2
SMZ25)
When the filter cube attached to the microscope is not on the list, you can configure any name.
Configuration procedures are described separately for LV100DA-U and SMZ18/SMZ25. See the relevant section.
For LV100DA-U
[Procedure]
[MIC SETUP] → [COMPONENTS]
(1)
Select the [FL TURRET] tab.
(2)
Press the turret address button to be configured.
Address 1 is fixed to BF and address 2 is fixed to DF. The
setting can be modified only for address 3 and 4.
(3)
Press the [CUSTOM] button on the filter cube
configuration screen.
To quit setting, press the [X] button.
(4)
Press the [INPUT] button, enter the name of the
attached filter cube (up to five characters), and then
press the [ENTER] button.
Pressing the
button removes a character at the end of
the data you entered.
Pressing the
button toggles between upper and lower
cases for alphabet letters.
Chapter 3
Settings
2-20
Advertisement
Table of Contents
Troubleshooting
