Bulk Saving Of Settings ([Main] Screen) - Nikon DS-L4 Instructions Manual

1

Bulk Saving of Settings ([MAIN] Screen)

After making changes on the [MIC SETUP], be sure to press the [SAVE] button on the [MIC SETUP] - [MAIN] to save the
settings to the microscope's memory. If the microscope is turned off without saving settings, previous values are restored.
[Procedure]
(1) After changing the settings, press the [MAIN] button to
go back to the [MIC SETUP] - [MAIN] screen.
(2) Press the [SAVE] button.
A confirmation dialog box appears.
If there is no data to be saved, the [SAVE] button is
disabled.
(3) Press the [OK] button.
Settings are saved.
To cancel saving, press the [CANCEL] button.
Pressing the [X] button on the upper-left of the screen
closes the [MIC SETUP].
Settings to be saved
Pressing the [SAVE] button saves the setting changes made since last save at one time. (Including the information
of the attached optical elements, microscope setting saved as a mode, and initial value of the interlock setting
[INTELLIGENT].)
If you want to save each setting individually, perform the above procedure each time you change the setting.
If you want the settings to be temporal (only while the microscope is turned on), you do not have to save the settings.
Chapter 6
Settings
1-77