Table of Contents
Advertisement
Arbitrarily Configuring the Data of Objective
2.1.2
When the objective attached to the microscope is not on the list, you can arbitrarily configure the objective's data. The
objective's data arbitrarily configured is registered to the memory (memory address 1 through 10).
[Procedure]
[MIC SETUP] → [COMPONENTS]
(1)
Select the [NOSEPIECE] tab.
(2)
Press the nosepiece address button to be configured.
(3)
Press the [CUSTOM] button on the objective
configuration screen.
The objectives registered to the memory are displayed.
To quit setting, press the [X] button.
When the data is already registered to the
memory
If the data for the objective to be used is already
registered to the memory, you can complete the
configuration by selecting the objective from the list
and pressing the [OK] button.
(4)
Select the memory address (1 - 10) to which you want
to register (or modify) the data.
Chapter 6
Settings
1-80
Advertisement
Table of Contents
Troubleshooting
