(5)
Press the [MODIFY] button and then [OK] button.
To cancel adding or saving, press the [CANCEL] button.
Removing the filter name registered to the
memory
To remove the filter name registered to a memory
address, press the [DELETE] button. If the filter
name to be removed has been registered to an
wheel address, settings in the wheel address will
also be removed.
(6)
Press the [INPUT] button, enter the name of the
attached excitation/barrier filter (up to nine
characters), and then press the [ENTER] button.
Pressing the
button removes a character at the end of
the data you entered.
Pressing the
button toggles between upper and lower
cases for alphabet letters.
(7)
Press the [OK] button.
(8)
Select the excitation/barrier filter registered to the
memory address and press the [OK] button.
Selected excitation/barrier filter is set to the wheel
address.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-91