Table of Contents
Advertisement
(5)
Press the [MODIFY] button and then [OK] button.
To cancel adding or saving, press the [CANCEL] button.
Removing the data registered to the
memory
To remove the data of the objective registered to the
memory address, press the [DELETE] button. If the
objective data registered for a nosepiece address is
the same as that deleted here, settings in the
nosepiece address will also be removed.
(6)
Select the name of the series of the objective attached
to the microscope and press the [NEXT] button.
When [▲] and [▼] buttons are shown under the list, you
can press [▲] or [▼] button to go to other pages.
(7)
Select the magnification of the objective attached to
the microscope and press the [NEXT] button.
To return to the previous screen, press the [BACK] button.
(8)
Press the [INPUT] button, enter the numerical aperture
of the attached objective, press the [ENTER] button,
and then the [NEXT] button.
Pressing the
button removes a character at the end of
the data you entered.
Chapter 6
Settings
1-81
Advertisement
Table of Contents
Troubleshooting
