Table of Contents
Advertisement
(9)
Select the immersion type of the objective attached to
the microscope and press the [NEXT] button.
(10) Press the [INPUT] button, enter the product code of
the attached objective, and then press the [ENTER]
button.
Pressing the
button removes a character at the end of
the data you entered.
Pressing the
button toggles between upper and lower
cases for alphabet letters.
(11) Press the [OK] button.
(12) Select the objective registered to the memory address
and press the [OK] button.
The selected objective is set to the nosepiece address.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-82
Advertisement
Table of Contents
Troubleshooting
