Nikon DS-L4 Instructions Manual page 126

[Procedure]
[MIC SETUP] → [BUTTON FUNC]
(1) Press the [FUNCTION SET] button under [ERGO
CONTROLLER].
Current settings are displayed.
(2) Press the button of which you want to change the
function assignment.
A sub screen to select a motorized device appears.
Pressing the [ALL CLEAR] button clears settings for all
buttons.
To quit setting, press the [X] button.
(3) Select the function you want to assign.
The selected function is shown with a check mark.
Pressing the [CLEAR] button assigns no function to the
button and the button becomes disabled.
(4) Repeat steps (2) and (3) if you want to change the
assignment for other buttons.
(5) Press the [OK] button.
[BUTTON FUNCTION] screen is displayed.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-114