Nikon DS-L4 Instructions Manual page 123

[Procedure]
[MIC SETUP] → [BUTTON FUNC]
(1) Press the [FUNCTION SET] button under [ERGO
CONTROLLER].
Current settings are displayed.
(2) Press the button for which you want to change the
motorized device assignment.
(Left: A, right: B)
A sub screen to select a motorized device appears.
Pressing the [ALL CLEAR] button clears settings for all
buttons.
To quit setting, press the [X] button.
(3) Select the motorized device you want to assign.
The selected motorized device is shown with a check
mark.
Pressing the [CLEAR] button assigns no motorized device
to the button and the button becomes disabled.
(4) Repeat steps (2) and (3) if you want to change the
assignment for another button.
(5) Press the [OK] button.
[BUTTON FUNCTION] screen is displayed.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-111