[Procedure]
[MIC SETUP] → [MOVEMENT]
(1)
Press the [SET] button under [OBJECTIVE
INTERLOCK].
Current settings are displayed.
(2)
If any change is required, press the button for the
intended objective.
Select relevant settings of escape state, aperture
diaphragm, ND wheel, and condense.
To quit setting, press the [X] button.
(3)
After completing the setting, press the [OK] button.
[MOVEMENT] screen is displayed.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-118