[Procedure]
[MIC SETUP] → [CONNECTION]
(1)
Press the button for the DSC connector to be
configured (left).
A sub screen opens to select the position of the connected
camera head.
(2)
Select [NOT-CONNECTED] if no camera is connected,
otherwise select the position.
(3)
Press the button for the DSC connector to be
configured (right).
A sub screen opens to select the position of the connected
camera head.
(4)
Select the manufacturer of the camera.
(5)
Repeat steps (2) and (3) when you use two DSC
connectors on Ni-E.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-94