Table of Contents
Advertisement
Automatically Switching the Movement Speed of the Microscope's Elevating
5.1.3
Section and Motorized Stage
The movement speed of the microscope's elevating section and motorized stage operated with the ergo controller (or
joystick) can be switched automatically according to the magnification of the objective.
Prerequisite for configuration
In order to perform this configuration, motorized (or intelligent) nosepiece, and ergo controller (or joystick) must be
attached. In addition, the information for objectives must be configured.
Setting Item
Setting Value
[XYZ SPEED]
ON
OFF (default)
[Procedure]
[MIC SETUP] → [MOVEMENT]
(1)
Press the [SET] button under [OBJECTIVE
INTERLOCK].
(2)
Press the [ON]/[OFF] button of [XYZ SPEED
INTERLOCK] to change the setting.
To quit setting, press the [X] button.
(3)
After completing the setting, press the [OK] button.
[MOVEMENT] screen is displayed.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
Operation to Be Interlocked
Changes the movement speed of the microscope's elevating section and
motorized stage according to the magnification of the objective:
2x, 4x, 10x: Coarse
20x, 40x: Fine
60x, 100x: Extra fine
Does not interlock.
1-120
Advertisement
Table of Contents
Troubleshooting
