Adjusting The Dia-Illumination Lamp/Led - Nikon DS-L4 Instructions Manual

Adjusting the Dia-illumination Lamp/LED

1.14
To switch over the control of the dia-illumination lamp/LED to turn the lamp ON/OFF, or adjust the brightness of the lamp,
use the [LAMP]/[LED] button.
Control of the dia-illumination lamp/LED
To control the dia-illumination lamp/LED from DS-L4, you must first transfer the control from the microscope to
DS-L4. If DS-L4 does not have control, the button will be grayed out and disabled. When DS-L4 has control, the
dia-illumination lamp/LED can also be controlled from the PC. Control of the dia-illumination lamp/LED is returned
to the microscope main body when the microscope is turned off.
Display Status of the [LAMP]/[LED] Button
[MICROSCOPE CONTROL] Screen
Ni-E Displayed by default
(Displayed by expanding [LAMP CTRL],
[ADJ.], [LAMP ON/OFF] button)
Ni-U Displayed by default
(Displayed by expanding [LAMP CTRL],
[ADJ.], [LAMP ON/OFF] button)
Ci-E -
(For details on displaying/hiding the buttons, refer to Chapter 6, "4.1.1 Selecting the Buttons to be Displayed".)
Transferring the Control of the Dia-illumination Lamp/LED
1.14.1
[Procedure]
(1) Press the [LAMP]/[LED] button.
(This operation is not required on the [MICROSCOPE
CONTROL] screen. Go to the next step.)
Following screens are for Ni-E/Ni-U. For Ci-E, it is
displayed as [LED] instead of [LAMP].
(2) Press the [LAMP CTRL]/[LED CTRL] button to transfer
the control.
The control is transferred between DS-L4 and the
microscope each time the [LAMP CTRL]/[LED CTRL]
button is pressed.
Chapter 5
Individual Operations
[MIC EASY] Screen
Displayed by default
Displayed by default
Displayed (cannot be changed)
[MIC EASY] Screen
[MICROSCOPE CONTROL] Screen
When DS-L4 does not have control
When DS-L4 has control
1-58