Table of Contents
Advertisement
(5)
Press the [MODIFY] button and then [OK] button.
To cancel adding or saving, press the [CANCEL] button.
Removing the module name registered to
the memory
To remove the module name registered to a
memory address, press the [DELETE] button. If
the module name to be removed has been
registered to a turret address, settings in the turret
address will also be removed.
(6)
Press the [INPUT] button, enter the name of the
attached condenser module (up to five characters),
and then press the [ENTER] button.
Pressing the
button removes a character at the end of
the data you entered.
Pressing the
button toggles between upper and lower
cases for alphabet letters.
(7)
Press the [OK] button.
(8)
Select the condenser module registered to the
memory address and press the [OK] button.
The selected condenser module is set to the turret
address.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-85
Advertisement
Table of Contents
Troubleshooting
