Table of Contents
Advertisement
(3)
Select the function you want to assign.
The selected function is shown with a check mark.
Pressing the [CLEAR] button assigns no function to the
button and the button becomes blank.
Layout of direct operation buttons
When placing direct operation buttons (buttons
which directly operate devices such as objectives
or condenser modules without showing sub
screen), select a main category button (with a
yellow frame), and then select a button shown
under it.
(4)
Repeat steps (2) and (3) for all buttons of which you
want to change the functions.
(5)
Press the [OK] button.
[BUTTON FUNCTION] screen is displayed.
To quit setting, press the [X] button.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-100
Advertisement
Table of Contents
Troubleshooting
