Table of Contents
Advertisement
Arbitrarily Configuring the Name of Excitation/Barrier Filter
2.4.2
When the excitation/barrier filter attached to the microscope is not on the list, you can configure any name. The name
arbitrarily configured is registered to the memory (memory address 1 through 10).
[Procedure]
[MIC SETUP] → [COMPONENTS]
(1)
Select the [EX WHEEL] or [BA WHEEL] tab.
Although the screens in the following procedure are those
when you select [EX WHEEL], similar screens are
displayed when you select [BA WHEEL].
(2)
Press the wheel address button to be configured.
(3)
Press the [CUSTOM] button on the excitation/barrier
filter configuration screen.
The excitation/barrier filters registered to the memory are
displayed.
To quit setting, press the [X] button.
When the excitation/barrier filter name is
already registered to the memory
If the name of the excitation/barrier filter to be
used is already registered to the memory, you can
complete the configuration by selecting the filter
from the list and pressing the [OK] button.
(4)
Select the memory address (1 - 10) to which you want
to register (or modify) the data.
Chapter 6
Settings
1-90
Advertisement
Table of Contents
Troubleshooting
