Table of Contents
Advertisement
(3)
(For AZ100M, SMZ18, SMZ25, and SMZ1270i)
Select the objective attached to the microscope and
press the [OK] button.
Step (4) is not required. Go to step (5).
To quit setting, press the [X] button.
(For MA200, L200N/L200ND, L300N/L300ND, LV150A,
LV-NCNT2, LV-NCNT-N, LV100DA-U)
Select the name of the series of the objective attached
to the microscope and press the [NEXT] button.
When [▲] and [▼] buttons are shown at the lower edge of
the list, you can press [▲] or [▼] button to go to other
pages.
To quit setting, press the [X] button.
(4)
(For MA200, L200N/L200ND, L300N/L300ND, LV150A,
LV-NCNT2, LV-NCNT-N, LV100DA-U)
Select the attached objective and press the [OK]
button.
The selected objective is set to the nosepiece address.
(5)
Repeat steps (3) and (4) for all nosepiece addresses to be configured.
After configuring, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the microscope's
memory (DS-L4's memory if LV150A or LV-NCNT2, or memory of nosepiece controller if LV-NCNT-N). If the microscope is
turned off without saving settings, previous values are restored. For more information on saving, see "1 Bulk Saving of
Settings ([MAIN] Screen)" in this chapter.
Chapter 3
Settings
2-15
Advertisement
Table of Contents
Troubleshooting
