Table of Contents
Advertisement
Configuring the Parfocal Correction Function (Auto Link Focus)
5.1.4
Parfocal correction is a function to automatically correct the difference between focal points of objectives when objective is
switched by configuring focal point of each objective in advance.
Note that parfocal correction is not performed when you switch objectives when the objective is retracted using the
[ESCAPE] button. When Auto Link Focus is ON, parfocal correction is performed when the objective is automatically
retracted or refocused according to the interlock setting of switching objectives.
Prerequisite for configuration
In order to perform this configuration, the motorized nosepiece must be attached.
Configuring the focal point
By setting the focal point for each objective, parfocal correction is appropriately performed when objectives are switched.
Be sure to perform this configuration if you plan to use parfocal correction.
[MIC SETUP] → [MOVEMENT]
(1)
Press the [SET] button under [OBJECTIVE
INTERLOCK].
(2)
If [AUTO LINK FOCUS] is set to [ON], change the
setting to [OFF].
The focal point can be set only when parfocal correction
(Auto Link Focus) is set to [OFF].
(3)
Press the [SET] button under [FOCUS POSITION].
(4)
Press the [ALL CLEAR] button.
Previous settings are removed.
Chapter 6
Settings
1-121
Advertisement
Table of Contents
Troubleshooting
