Configuring The Function Of The Ergo Controller Buttons - Nikon DS-L4 Instructions Manual

Configuring the Function of the Ergo Controller Buttons

4.3
You can change the functions of the ergo controller buttons.
Prerequisite for configuration
In order to configure this setting, the ergo controller must be connected.
Configurable buttons are shown below.
Button 1 (top left)
Target of the CW/CCW buttons (two)
 A-side (when left LED is turned on)
 B-side (when right LED is turned on)
Button 3 (bottom left)
Default targets of the CW/CCW buttons are as follows:
Setting Item
A-side (when left LED is turned on)
B-side (when right LED is turned on)
Default settings for buttons 1 through 5 are as follows:
Setting Item
Button 1 (top left)
Button 2 (top right)
Button 3 (bottom left)
Button 4 (bottom center)
Button 5 (bottom right)
Chapter 6
Settings
Z Speed XY Speed
FL cube OBJ
Fl shutter B/F/R EPI all
Button 4 (bottom center)
Target
Motorized epi-fluorescence cube turret (1st layer)
Motorized nosepiece
Function
Z SPEED
XY SPEED
SHUTTER FL
B/F/R
SHUTTER EPI ALL
1-109
Button 2 (top right)
Button 5 (bottom right)