Table of Contents
Advertisement
Configuring the Addresses Used by Toggle Function
5.5.2
[Procedure]
[MIC SETUP] → [MOVEMENT]
(1)
Press the [SET] button under [NOSEPIECE TOGGLE]
(this operation is not required for Ci-E. Go to the next
step.)
(2)
For [PATTERN 1] or [PATTERN 2], press two buttons
for addresses you want to use for toggle function.
Two addresses can be specified for each toggle pattern.
Specifying third address cancels the address you specified
first.
To quit setting, press the [X] button. (Ni-E only)
(3)
Press the [OK] button (this operation is not required
for Ci-E).
[MOVEMENT] screen is displayed.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
(For Ni-E)
(For Ni-E)
(For Ci-E)
1-134
Advertisement
Table of Contents
Troubleshooting
