Configuring Other Functions ([Utility] Screen, [Maintenance] Screen); Setting The Display Of The Ni-E Front Display Panel - Nikon DS-L4 Instructions Manual

6
Configuring Other Functions ([UTILITY] Screen, [MAINTENANCE]

Setting the Display of the Ni-E Front Display Panel

6.1
There are nine status display patterns for the front display panel of the Ni-E main body. Patters displayed at the startup
can be changed by this setting.
By default, pattern 1 is displayed. (For different display patterns, refer to the Ni-E instruction manual "Operation".)
[Procedure]
[MIC SETUP] → [UTILITY]
(1) Press the [DISPLAY PATTERN SET] button under [Ni-E
DISPLAY PANEL].
A dialog screen appears.
(2) Press the DISPLAY Previous/Next button on the main
body to switch to the pattern to display at startup.
You can switch between status display and FUNCTION
button's function display by pressing the microscope's
DISPLAY toggle button. You can also set the FUNCTION
button's function display as the pattern for startup.
(3) Press the [OK] button.
The pattern selected in step (2) is set as the display
pattern at startup.
To quit setting, press the [CANCEL] button.
After making changes to the settings, be sure to press the [SAVE] button on the [MAIN] screen to save the settings to the
microscope's memory. If the microscope is turned off without saving settings, previous values are restored. For more
information on saving, see "1 Bulk Saving of Settings ([MAIN] Screen)" in this chapter.
Chapter 6
Settings
1-136
Screen)