Skewed Copy Image
Step
Questions and Actions
Ensure the original copy being used is
1
1.
supported by this system and undamaged.
Ensure the paper guides are adjusted
2
1.
securely against the original.
Clean the pick roller and separator pad.
2.
Make another copy.
3.
Did this correct the problem?
4.
See the "Media System Skew Specification
3
1.
(IIT/IOT)" on page 1-20.
Is the skew within specification?
2.
Perform the "Manual DADF to Scanner
4
1.
Calibration" on page 6-9.
Did this correct the problem?
2.
Copy Image is Lighter/Darker than the Original
Step
Questions and Actions
Ensure supported media is being used.
1
1.
Check and/or adjust the control panel copy
2.
settings. Print the Troubleshooting Print
Quality information page from the control
panel and review Output Quality and Color
Settings section to aid in adjusting copy
settings.
Does adjusting the copy settings correct the
3.
problem?
Perform the "Manual DADF to Scanner
2
1.
Calibration" on page 6-9.
Did this correct the problem?
2.
Image-Quality Troubleshooting
Yes
Go to Step 2.
Use the platen.
Complete.
Go to Step 3.
Complete.
Go to Step 4.
Complete.
Replace the
document
feeder.
Yes
Complete.
Go to Step 2.
Complete.
Replace the
document
feeder.
No
No
5-5