Mitsubishi Electric Melsec Q Series Programming Manual page 398

5 OPERATION CONTROL PROGRAMS
Synchronous position adjustment = 20.0mm
(The retracting section is adjusted to the
sheet end side.)
Sheet synchronization width = 30.0mm+20.0mm
Acceleration/deceleration width = 55.0mm
Cam axis (Synchronous axis) speed
(3) Program examples
(a) Program which creates cam data (resolution: 512) for the rotary cutter
operation pattern in Cam No.5.
D5000L=K512
D5002=K0
D5003=K300
D5004L=K2000
D5006L=K500
D5008L=K1000
D5010L=K200
D5012L=K550
D5014=K1
CAMMK K5,K1,D5000 // Cam auto-generation (Asynchronous speed result is stored
Synchronous speed
(Feed sheet speed)
// Resolution = 512
// Acceleration/deceleration system = Trapezoidal,
Synchronous axis length setting = Diameter
// Synchronous section acceleration ratio = 3.00%
// Sheet length = 200.0mm
// Sheet synchronization width = 30.0mm (Seal section) +
20.0mm (Retracting operation)
// Synchronous axis length = 100.0mm(Diameter)
// Synchronous position adjustment = 20.0mm
// Acceleration/deceleration width = 55.0mm
// Number of cutter = 1
in D5015.)
Synchronous
axis
Sheet length = 200.0mm
Synchronous section acceleration ratio = 3.00%
Center of sheet
5 - 175
Synchronous axis length = 100.0mm (Diameter)
Acceleration/deceleration width = 55.0mm
Feed sheet
Asynchronous speed
t