Table of Contents
Advertisement
Side-discharging the Clippings
Use the side discharge for cutting very tall grass.
If the bag is on the mower, remove it and insert the rear
discharge plug (refer to Removing the Grass Bag) before
side-discharging the clippings.
Important: Ensure that the rear discharge plug is
securely in place. Lift up the discharge deflector
and look for 2 tabs in front of the plug (Figure 28).
If you do not see them, firmly push the plug in until
it snaps into place (Figure 29).
Figure 28
1. Tabs
Figure 29
1. Discharge deflector
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
Installing the Side Discharge Chute
1. Unlock the side discharge door (Figure 30).
2. Rear discharge plug
2. Lift open the side discharge door (Figure 31).
3. Install the side discharge chute and close the door
onto the chute (Figure 32).
Removing the Side Discharge Chute
To remove the side discharge chute, reverse the steps
above.
Important: Lock the side discharge door after you
close it (Figure 33).
13
Figure 30
Figure 31
Figure 32
Figure 33
Advertisement
Table of Contents
