Testing The Electrical Components - Toro Field Pro 6040 Service Manual

Testing the Electrical Components

Field Pro® 6040
22267SL Rev A
For accurate resistance and/or continuity checks, electrically disconnect the
component being tested from the circuit (e.g., disconnect the key switch
connector before doing a continuity check of the switch).
When testing the electrical components for continuity with a
multimeter (ohms setting), ensure that you disconnect the power to
the circuit.
Note: For engine component testing information (fuel solenoid, charging
system, ignition modules, starter); refer to the KOHLER Command CH18-CH25,
CH620-CH730, CH740, CH750 Service Manual.
IMPORTANT
Page 6–5 Electrical System: Testing the Electrical Components