Removing The Separation Static Eliminator - Canon imageRUNNER ADVANCE 4551i Service Manual

3. Remove the Transfer Roller [1].
• 1 Stopper (Front) [2]
• 1 Claw [3]
• 1 Shaft Support (Rear) [4]
CAUTION:
Points to Note at Installation
• Be sure to install it so that the longitudinal side of the Transfer Roller is positioned on the rear side of the host machine.
• Be sure to fit the spring [1] of the Transfer Roller onto the boss [2].
NOTE:
When the consumable parts have been replaced, be sure to clear the parts counter shown below in service mode.
• COPIER > COUNTER > DRBL-1 > TR-ROLL

Removing the Separation Static Eliminator

■ Procedure
1. Open the Right Cover.
2. Remove the Separation Static Eliminator [1].
• 1 Claw [2]
1x
2
[4]
257
[3]
[1]
[2]
[1]
4. Disassembly/Assembly
[2]
1