Canon imageRUNNER ADVANCE 4551i Service Manual page 882

SORTER > OPTION
PNCH-SW2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
PNCH-SW3 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
SFT-CHNG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
STP-ALG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Setting of punch hole spec: Fin-J1/Y1
To set the punch hole specification of puncher unit.
When replacing the Puncher Unit
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When the punch hole specification is not set, malfunction may occur in the punch operation.
0: 2/4 holes puncher unit
1: 2/3 holes puncher unit
2: SWE 4 holes puncher unit
0
Set punch hole hi precision mode: Fin-Y1
To set ON/OFF of the mode to improve the precision of the punch hole position.
When 1 is set, the punch hole position is decided by the paper trailing edge standard.
When the position of the punch hole is misaligned
Enter the setting value, and then press OK key.
- When setting to ON, the productivity is decreased.
- When setting the punch mode to the precision priority, this mode enables.
cannot be executed.
0 to 1
0: OFF, 1: ON
0
SORTER>OPTION>PUCH-SW
SORTER>OPTION>PUN-Y-SW
Adjustment/Maintenance> Adjust Action> Switch Finisher Puncher Mode
Set dvry number of stck ppr: Fin-Y1
Setting the number of paper in a stack delivery for small sizes at shift sort mode.
Changing the setting to "1", the number of paper in a stack delivery changes as follows:
- For plain paper 1 and 2: Number of paper in a stack changes from 5 to 2.
- For plain paper 3: Number of paper in a stack changes from 3 to 2.
The above setting is not effective for the paper that is more than 106 g/m2 or tab paper ,coated
paper.
When improving the stacking alignment during the delivery of the stacking paper except for the
paper that is more than 106 g/m2 or tab paper ,coated paper.
Enter the setting value, and then press OK key.
- When setting of SORTER>OPTION>BUFF-SW is "1", the number of paper in a stack is fixed at
5 for plain paper 1, 2 and 3 regardless of the setting of this mode.
- There is no simultaneous stack ejection operation for small sizes in the shift sort mode.
0 to 1
0: OFF, 1: ON
1
Set align plate oprtn at stpl mod:Fin-Y1
To set the operation of alignment plates at staple mode and staple-free binding mode.
Set to 1 when the alignment operation by the alignment plates is changed from one time to two
times at the staple mode and staple-free binding mode.
When improving the alignment (front/rear) of the paper at staple mode
Enter the setting value, and then press OK key.
When setting to ON, productivity is decreased.
0 to 1
0: OFF, 1: ON
0
869
8. Service Mode